Why doesn't l&tt for windows see my usb drives, Csi questions, Why does l&tt for windows not see my usb drives – HP StoreEver TapeAssure Software User Manual
Page 189
L&TT starts in restricted mode and most functionality is unavailable. What is
happening?
L&TT automatically runs in restricted mode when it recognizes a supported device that has a
problem with firmware and requires a firmware upgrade. There are two basic scenarios:
•
L&TT recognizes the device, but the device is in brain dead mode. This usually indicates that
the device firmware is corrupt and the device is responding via boot code only.
•
L&TT recognizes the device by means of the product ID code, but L&TT does not recognize
the personality codes of the device.
If one of these scenarios exist, then L&TT displays a message stating that it is running in restricted
mode when it is started. The functionality of L&TT is restricted as follows:
•
All features are disabled except for firmware update and support ticket.
•
The support ticket shows basic information only and excludes device details.
•
For firmware upgrades, L&TT enforces the Allow all files to be selected option,
and the Options button is unavailable because all options are preset.
To exit restricted mode, exit and restart L&TT. L&TT will continue to start in restricted mode until the
problem with the offending device is resolved, or the device is disconnected.
Why doesn't L&TT for Windows see devices that are connected to a computer running
HP-UX?
L&TT does not support a client-server model such as the HP-UX Support Tools Manager. You cannot
use L&TT on a Windows workstation to view devices that are connected to a computer running
HP-UX.
Why doesn't L&TT for Windows see my USB drives?
The ASPI driver does not support USB drives. Make sure that you are using the Miniport driver.
CSI questions
•
•
Why does my display not show any text or only a single line of text on my HP-UX system?
•
Why is there a segmentatio fault when L&TT is initiated in HP-UX?
•
Why does L&TT for HP-UX not see some of my devices?
•
Why doesn't L&TT for HP-UX see all the devices connected to a SAN environment?
•
•
Why does L&TT for Tru64 not see some of my devices?
•
Why does L&TT for Linux not see some of my devices?
•
Why does L&TT for Windows not see devices that are connected to a computer running HP-UX?
•
How do I disconnect a SCSI device in Tru64?
•
How do I connect/disconnect a SCSI device in Linux without rebooting?
•
Why does L&TT for OpenVMS not see my media changer?
•
Why am I getting Error activating image PTHREAD$RTL while running L&TT on Open VMS
7.3-1?
CSI questions 189