beautypg.com

Dlt sram check test (short and long versions), Esl vendor id test, Full sweep test – HP StoreEver TapeAssure Software User Manual

Page 112

background image

DLT SRAM Check test (short and long versions)

CAUTION:

These tests are destructive and will overwrite data on the media that is present in your

product.

Description

These tests check DLT 8000 drive logs for evidence of SRAM chip
corruption, and they perform a read/write test to check the drive for
susceptibility to SRAM corruption problems. The tests are destructive to
data on the cartridge in the drive. These tests are only available for DLT
drives.

NOTE:

For instructions on how to perform this test, see

Running the

tests (GUI) (page 40)

or

Running the tests (CSI) (page 73)

.

When to run

Run the short version of the test when you suspect the drive may be
responsible for CRC errors and want to do a quick test to verify. Run
the long version to perform a more extensive analysis.

Average duration

~20 minutes (short version), or up to 1.5 hours (long version)

Other notes

You must have a write-enabled tape in the drive, and the drive must be
ready before starting this test or it will fail. Test will overwrite all data
on the media.

Available for

DLT 8000

ESL Vendor ID test

Description

Toggles the Vendor ID in an ESL library between HP and Compaq.

NOTE:

For instructions on how to perform this test, see

Running the

tests (GUI) (page 40)

or

Running the tests (CSI) (page 73)

.

When to run

Run this test to change the vendor ID, which may be required for some
applications to work properly.

Average duration

< 1 minute

Other notes

Test requires firmware version 3.40 or later.

Available for

ESL libraries

Full Sweep test

Description

This test script moves the robotics through the full range of motion to
help prevent reliability issues with the brush tracks. This test is available
for the C7200 and C7145 library models.

NOTE:

For instructions on how to perform this test, see

Running the

tests (GUI) (page 40)

or

Running the tests (CSI) (page 73)

.

When to run

Run this test if the results of a Device Analysis test recommend that you
run this test. This recommendation is based on reviewing library log
data for certain critical errors, including those related to issues with the
brush tracks.

Average duration

Up to 2.5 hours, depending on whether the long or short test is selected.

Other notes

Test will not overwrite any data on the media. Data from this test is
logged into the library for future use by support personnel.

Available for

C7145 and C7200 libraries

112

Tests and utility functions

This manual is related to the following products: