Running l&tt from a shared directory – HP StoreEver TapeAssure Software User Manual
Page 179
(Linux)
1.
Fully install L&TT onto a computer. If desired, also install any necessary firmware files into the
firmware
subdirectory.
2.
Remove the logs directory from the L&TT install directory.
3.
Write the contents of the L&TT install directory (/opt/ltt) to the root directory of a CD or
USB flash drive. Close the CD.
4.
Insert the CD or USB flash drive into any Linux system and mount the CD or USB flash drive.
From the mount path run hp_ltt as you would on any other Linux system.
When L&TT is run from a CD, USB flash drive, or remote directory, L&TT will prompt you for the
directory where the temporary files and reports will be placed, as shown in
and
. This directory can be removed once L&TT is stopped.
Figure 80 Prompt for temporary file directory (Windows)
Figure 81 Prompt for temporary file directory (Linux)
Running L&TT from a shared directory
You can run L&TT from a shared network directory. This approach is most useful when running
L&TT on a computer that already has shared directory access to another computer.
To install L&TT on a computer in preparation for running it remotely from another computer:
•
Fully install L&TT onto a computer in a directory that will be accessible to other computers. If
desired, also install any necessary firmware files into the firmware subdirectory.
(Windows) To run L&TT from a remote directory:
Running L&TT from computers without L&TT installed
179