beautypg.com

Device self-test – HP StoreEver TapeAssure Software User Manual

Page 109

background image

Command line syntax

The Device Analysis test is available from the command line. For
more information, see

Running tests (CLF) (page 91)

.

Test name: Device Analysis

Options: None

When to run

Run this test when you want to verify that basic functions of the
device are operating properly and have not logged any critical
errors, and to verify that firmware is up to date.

Average duration

< 1 minute

Other notes

Test does not change the configuration of the drive or media.

Available for

All devices supported by L&TT

Device Self-Test

Description

This test executes the internal self-test of the device and reports any
failures. This test is useful in confirming that the device itself is
operating properly. Not all devices support an internal self-test.

NOTE:

For instructions on how to perform this test, see

Running

the tests (GUI) (page 40)

or

Running the tests (CSI) (page 73)

.

Command line syntax

The Device Self-Test is available from the command line. For more
information, see

Running tests (CLF) (page 91)

.

Test name: Device Self Test

Options:

Looping Options

—Specify Count based loop or Time

based loop(min)

. In either case, the actual value is entered

separately using the Looping value parameter.

For example, to set a time-based loop of 10 minutes:

testopt=”Looping Options:Time based loop(min)”

testopt=”Looping value:10”

Looping value—Specify an integer greater than zero.

For example, to set a count-based loop to iterate five times:

testopt=”Looping Options:Count based loop”

testopt=”Looping value:5”

NOTE:

If no options are specified, L&TT runs the test with looping

options set to Count based loop with a looping value of 1.

When to run

Run this test as a quick check of the integrity of the device.

Average duration

< 1 minute

Other notes

Test will not overwrite any data on media present in the drive.

Available for

AIT, DDS, DLT, SDLT, VS80/VS160 or DLT1, LTO autoloaders and
drives, ESL, MSL, C7200, C7145, C5177, C1194F, C5151,
C5173, C6280, SSL 1016 and STK libraries, STK 9840 drives,
MO drives & libraries, and A6356A Fibre Channel management
card

Diagnostic tests 109

This manual is related to the following products: