GW Instek PEL-2000 Series User Manual - Manual (Page 72)

PEL-2000 Series User Manual
72
P/F-Time Off – 0.1 ~ (On-time+Off-time)-0.1
Short Channel CH1 ~ CH8
Program Sequences are run sequentially to create a Program.
There are 10 Sequences in each Program.
If less than 10 Sequences are desired for a Program,
any additional Sequences can be skipped (not run).
Sequence 2 & 3 are skipped.
Program Chain Any of the 12 programs can be chained together to
create a Program Chain. Unlike Program
Sequences, Program Chains need not be run
sequentially in numerical order. Any program can
be chained to any program. It is possible to chain
programs into an infinite loop to continue a
program indefinitely.
Above, a program chain running sequences out-of-
order.