GW Instek PEL-2000 Series User Manual - Manual (Page 107)

TUTORIALS
107
9. Monitor Use IMON and VMON to monitor
the current and voltage of load
outputs. Page 85
10. End To turn the load off, output an
active high signal to the channel
control connector, or press the
LOAD key on the load module or
mainframe**.
* Mode and Range cannot be configured via the Channel
Control (CH CONT) interface. Mode and Range can only be
configured via the front panel.
** The LOAD key cannot always be used to turn on/off the
load. See page 85 for details.