GW Instek PEL-2000 Series User Manual - Manual (Page 30)

PEL-2000 Series User Manual
30
Positive and
Negative
Terminals Right For 2 channel load modules, the left
terminals are used for the 1
st
channel and the right terminals are
used for the 2
nd channel.
On single channel load modules,
the left terminals are the lower (-)
potential terminals, whilst the right
terminals are the positive (+)
potential terminals.
Static/Dynamic
Selector Key The STATIC/DYNA. Key manually
switches the load from Static
(manual) to Dynamic loads.
Dynamic loads are only supported
in CC and CR mode.
For more information see page 61 &
65.
Selector Knob
(Load) The load Selector Knob is used to
edit and vary parameters for the
active channel on the local load.
Depending on the Mainframe
setup, the Selector Knob will either
only update the load (locally) or
will update both the local module
and the mainframe*. The Selector
knob can also be configured to
display measured or set values on
the local load module**.
* For more information on “Knob Type”, see
page 188.
** For more information on “Slave Knob”,
see page 192.