GW Instek PEL-2000 Series User Manual - Manual (Page 108)

PEL-2000 Series User Manual
108
General Configuration Options
There are number of different options for each channel. The
different options are described below.
Options Description Details
1. CC Vrange Configure the CC Voltage range
from high or low. Page 165
2. Von Voltage Configure the Von Voltage settings. Page 167
3. Short key Configure the short key to toggle or
hold. Page 168
4. CH CONT Turn channel control on/off Page 170
5. Independent
load
Turn the load module control to
dependent (via mainframe) or
independent control. Page 171
6. Delay Time Configure the load delay time for
each channel. (0-10 seconds). Page 173
7. Clear All
Protection
Clear all the Protection Alarms. Page 165
8. Time Configure date time settings. Page 183
9. Display Adjust display settings. Page 184
10. Control type Configure the Knob control. Page 188
11. Slave Knob
Setting
Display Measured or Set values
with the selector knob. Page 192
12. Alarm Configure alarm settings. Page 190
13. Step
resolution
Configure the step resolution.
Applicable to CC high and low
range, CR high and low range and
CV high range. Page 175
14. Sound Turn the sound on/off for the
mainframe IU. Page 184