GW Instek PEL-2000 Series User Manual - Manual (Page 138)

PEL-2000 Series User Manual
138
Creating a Program Sequence
Background The PEL series has a total of 12 different programs
and 10 sequences to each program. That totals to
120 different configurations.
Each Sequence in each program uses the settings
saved from Memory Data (Memory MXXX).
Memory Data contains settings such as the mode
and range for each channel. Different Sequences
can use the same Memory Data repeatedly. Each
Sequence loads all channels at the same time,
unless programmed otherwise.
CH2 M001
CH3 M001
CH1 M001 Run
On-Time
Off-Time
Short-Time
Short CH1
Short CH8
P/F-Time CH5 M001
CH6 M001
CH4 M001
CH8 M001
CH7 M001
Sequence1
Sequences are run sequentially to create a
Program. There are 10 Sequences in each Program.
If less than 10 Sequences are desired for a Program,
any additional Sequences can be skipped (not run).
Sequence 2 & 3 are skipped.