GW Instek PEL-2000 Series User Manual - Manual (Page 174)

PEL-2000 Series User Manual
174
03/02/09
10 : 30
CC
Dyna
High
Configure
Previous
Menu
Protection Go-NoGo
CH1
Other
S
Ω
Ω
Conf
2. Use the Selector knob to
highlight Load D-Time.
Note: Load D-Time is below
Independent, off-screen.
3. Press the Selector knob to edit
the selected setting, turn to
change the setting.
OR
Use the number pad to enter a
number.
4. Press the Selector knob or Enter
to confirm selection.
Note
The Delay Time only applies to the current channel;
other channels will not be affected.
Delay time only applies when the load is manually
turned on or during start up with the Auto Load On
setting (page 182).