GW Instek PEL-2000 Series User Manual - Manual (Page 66)

PEL-2000 Series User Manual
66
Single Load
Module
Dynamic
Functions CR mode supports Dynamic loading. Dynamic
load has two resistance levels (Level 1&2), and two
timers (Timer 1&2) to switch between the
resistance levels. Rising and falling slew rates can
be set to determine the speed at which the load
generator switches between load levels.
Slew Rate The rising and falling slew rate (A/uS) determines
the speed at which the load levels change from A
to B Value (Static mode) or from Level1 to 2
(Dynamic mode) and vice versa.
Go/NoGo Go/NoGo is also supported. Center, High and
Low limits can be set as either percentages or
voltage values. A delay time of up to 1 second can
also be set.