GW Instek PEL-2000 Series User Manual - Manual (Page 70)

PEL-2000 Series User Manual
70
Response Speed Response speed can be set to fast or slow. Fast
response and slow response is determined by the
load module specifications. Slow response speeds
are suitable for large loads as quick current
changes will induce induction which can cause
large voltage drops. The PEL series will try to
rectify any voltage drops. However if voltage
drops are too large, they may cause the load
generator to go into oscillation. Large voltage
drops caused by line voltage induction may
damage the machine.
Range Fast Slow
1kHz 100Hz
Go/NoGo Go/NoGo testing can be with either current
(Ampere) values (High, Low) or percentage values
(Center, High %, Low %). A delay time of up to 1
second can also be set.