GW Instek PEL-2000 Series User Manual - Manual (Page 241)

FAQ
241
F
AQ
Q1. The load voltage indicated on the load module is below expected.
A1. Ensure the load leads are as short as possible, twisted and use
the appropriate wire gauge. Ensure that voltage sense is used, this
can help alleviate the voltage drop across the load the leads.
Q2. When I try to start a program sequence, it will not run. “No Active
Channel” is displayed.
A2. Ensure the channel(s) is activated (not set to OFF) in the
FUNCProgramActive Channel menu.
Q3. When trying to save to USB, the USB memory stick is unresponsive.
A3. Try restarting the PEL mainframe. If this fails to solve the
problem, ensure the USB memory is cleanly formatted.
Q4. When I try to clear an alarm, it doesn’t work.
A4. Before clearing an alarm or using the Protection Clear All
function, the load must be turned off. After the load is off, the
alarm(s) can be cleared.
Q5. Settings aren’t saved to internal memory.
A5. If settings can’t be saved to internal memory, the internal
battery may be flat. See page 243 for details.
For more information, contact your local dealer or GWInstek at
www.gwinstek.com / [email protected].