Installation, Load module installation – GW Instek PEL-2000 Series User Manual User Manual

Page 35

Text mode
Original mode

GETTING

STARTED

Installation

The installation chapter describes how to load the different load
modules, install the optional GPIB card, the rack mount kit and
how to determine each channel number.

Load Module Installation

WARNING

To avoid static electricity, please use appropriate anti-
static work practices.

Module
installation

The PEL-2004 and 2002 can accommodate 4 and 2
load modules, respectively. Module loads can have
1 or 2 channels. Installation of load modules is the
same for both models.

Steps

1. Ensure the PEL mainframe is

turned off from the rear panel.
Disconnect the power cord.

2. Slide the module onto the rails of an empty

load slot.