GW Instek PEL-2000 Series User Manual - Manual (Page 141)

OPERATION
141
Choose which Memory data will be
used for the sequence. CH1 MXXX ~
CH8 MXXX.
Run: Skip – Auto - Manual
Choose whether to run the sequence in
the program automatically, skip the
sequence or manually start the
sequence.
On-Time: 0.1 ~ 60.0 seconds
Determines how long the sequence will
run for (seconds).
Off-Time: Off – 0.1 ~ 60.0 seconds
Sets how long the sequence will stay off
for (in seconds) between each sequence.
Assuming Short time is not set to OFF,
Off-Time will always run after On-
Time.
Short Time: Off – 0.1 ~ On-Time (seconds)
Determines how long a short circuit will
last (seconds). However the shorting
time cannot be longer than the On-time.
Short Time will start at the same time as
On-time.
P/F Time: Off – 0.1 ~ (On-Time+Off-Time)-0.1
(seconds)