GW Instek PEL-2000 Series User Manual - Manual (Page 131)

OPERATION
131
Panel Operation 1. Use the Selector knob to
highlight Level1.
03/02/09
10 : 30
CR
Dyna
Low
Configure Configure
Mode
CR
Dynamic
CH1
Range
Low
Ω
Ω
Main
2. Press the Selector knob to edit
the selected level, then turn to
increase or decrease the value.
OR
Use the number pad to enter a
number.
3. Press the Selector knob or Enter
to confirm selection.
4. Repeat steps 1-3 for the
remaining parameters.
Note
Level1 & Level2 can be set for both High and Low
Range.