GW Instek PEL-2000 Series User Manual - Manual (Page 236)

PEL-2000 Series User Manual
236
5 Load On Load On Input.
Load on = Active low, 0-1V
Load off = Active high, 4-5V.
(Using the + load polarity in
conjunction with a 10kΩ pull up
resistor)
6 +15V Internal power output. Max
50mA.
Channel Control
Interface
Constraints Mode/Range Mode and Range configuration
is only selected via the front
panel.
Configure Frame Link Interface
Connection Connect the Frame link cable
(MIL 20 pin connector) to the
rear panel port: 20-pin male
connector.
Pin assignment
(Frame link
connector 1)
Pin1 A Recall Preset memory 0
(All channels)
Pin2 B Recall Preset memory 1
(All channels)
Pin3 C Recall Preset memory 2
(All channels)
Pin4 TRIG_OUT Trigger out
Pin5 MEM_0 Recall Setup memory 1
(All channels)
Pin6 MEM_1 Recall Setup memory 2
(All channels)