GW Instek PEL-2000 Series User Manual - Manual (Page 192)

PEL-2000 Series User Manual
192
03/02/09
10 : 30
Configure Other
System
Info
Load Interface Time Set
3. Use the Selector knob to move
the cursor down to Go-NoGo
Tone (below the initial screen).
4. Press the Selector knob to
highlight Go-NoGo Tone, then
turn to change to ON/OFF.
5. Press the Selector Knob or Enter
to confirm selection.
Adjusting Slave Knob Settings
Background Channel loads can be edited using the local load
module or the Mainframe. When using the local
load module selector knob (slave knob) to edit a
load, the load module display can be set to two
different types: SetValue and Measured.
When a load is ON, SetValue will always display
the set value (A Value, B Value) on the local load