GW Instek PEL-2000 Series User Manual - Manual (Page 237)

INTERFACE
237
Pin7 MEM_2 Recall Setup memory 3
(All channels)
Pin8 MEM_3 Recall Setup memory 4
(All channels)
Pin9 Enable Enable Load (On/Off),
recall Preset memory (0-
3) and Setup memory (1-
4)
Pin10 Load On/Off
Pin11 Not used
Pin12 Not used
Pin13 Not used
Pin14 Not used
Pin15 Load Status Output, load on status.
Pin16 Alarm Status Output alarm activated.
Pin17 +5V Output, 5V+, 100mA.
Pin18 N.C No connection.
Pin19 GND Ground
Pin20 GND Ground
Pin assignment
(Frame link
connector 2)
Pin1 Sync._A Sync signal, Recall Preset
memory 0 (All channels)
Pin2 Sync._B Sync signal, Recall Preset
memory 1 (All channels)
Pin3 Sync._C Sync signal, Recall Preset
memory 2 (All channels)
Pin4 AUX Reserved