GW Instek AFG-2225 User Manual - Manual (Page 296)

AFG-2225 Series User Manual
296
Input Impedance 10kΩ
Frequency DC to 20kHz
Trigger Output
Type For Burst, Sweep, Arb
Level TTL Compatible into 50Ω
Pulse Width >450ns
Maximum Rate 1MHz
Fan-out ≥4 TTL Load
Impedance 50Ω Typical
Dual Channel Function
Phase -180˚ ~180˚ -180˚ ~ 180˚
Synchronize phase Synchronize phase
Track CH2=CH1 CH1=CH2
Coupling Frequency(Ratio or
Difference) Frequency(Ratio or
Difference)
Amplitude & DC
Offset Amplitude & DC
Offset
Dsolink √ √
Burst
Waveforms Sine, Square, Ramp Sine, Square, Ramp
Frequency 1uHz~25MHz 1uHz~25MHz
Burst Count 1 to 65535 cycles or
Infinite 1 to 65535 cycles or
Infinite
Start/Stop Phase -360 to +360 -360 to +360
Internal Period 1ms to 500s 1ms to 500s
Gate Source External Trigger External Trigger
Trigger Source Single, External or
Internal Rate Single, External or
Internal Rate
Trigger Delay N-Cycle, Infinite 0s to 655350ns 0s to 655350ns
Frequency Counter
Range 5Hz to 150MHz
Accuracy Time Base accuracy±1count
Time Base ±20ppm (23˚C ±5˚C) after 30 minutes warm
up
Resolution The maximum resolution is:
100nHz for 1Hz, 0.1Hz for 100MHz.
Input Impedance 1kΩ/1pf
Sensitivity 35mVrms ~ 30Vms (5Hz to 150MHz)
Save/Recall 10 Groups of Setting Memories
Interface USB (Host&Device)
Display TFT
General Specifications
Power Source AC100~240V, 50~60Hz
Power Consumption 25 W (Max)
Operating
Environment Temperature to satisfy the specification : 18 ~
28˚C
Operating temperature :
0 ~ 40˚C
Relative Humidity:
＜ 80%, 0 ~ 40˚C
Installation category： CAT II