GW Instek AFG-2225 User Manual - Manual (Page 208)

AFG-2225 Series User Manual
208
Noise
Not applicable
User
1μHz~60MHz
If the function mode is changed and the current
frequency setting is not supported by the new
mode, the frequency setting will be altered to next
highest value.
The duty cycle of square waveforms depends on the
frequency settings.
1.0% to 99.0%(frequency≤100 KHz)
10% to 90% (100 KHz ≤ frequency ≤1MHz)
50% (frequency ≤ 25 MHz)
If the frequency is changed and the set duty cycle
cannot support the new frequency, the highest
duty cycle available at that frequency will be used.
A “settings conflict” error will result from the
above scenario.
Syntax SOURce[1|2]:FREQuency
{|MINimum|MAXimum}
Example SOUR1:FREQ MAX
Sets the frequency to the maximum for the current
mode.
Query Syntax SOURce[1|2]:FREQuency?
Return Parameter Returns the frequency for
the current mode.
Example SOUR1:FREQ? MAX
+1.0000000000000E+06
The maximum frequency that can be set for the
current function is 1MHz.