GW Instek AFG-2225 User Manual - Manual (Page 280)

AFG-2225 Series User Manual
280
-221 Settings conflict;offset changed due to amplitude
Example: The offset is not a valid offset value, it is
automatically adjusted, considering the amplitude.
|offset|≤ max amplitude – Vpp/2
-221 Settings conflict;amplitude changed due to offset
Example: The amplitude is not a valid value, it is
automatically adjusted, considering the offset.
Vpp ≤ 2X (max amplitude -|offset|)
-221 Settings conflict;low level changed due to high level
Example: The low level value was set too high. The
low level is set 1 mV less than the high level.
-221 Settings conflict;high level changed due to low level
Example: The high level value was set too low. The
high level is set 1 mV greater than the low level.
-222 Data out of range;value clipped to upper limit
Example: The parameter was set out of range. The
parameter is automatically set to the maximum
value allowed.
SOURce[1|2]:FREQuency 25.1MHz.
-222 Data out of range;value clipped to lower limit
Example: The parameter was set out of range. The
parameter is automatically set to the minimum value
allowed.
SOURce[1|2]:FREQuency 0.1μHz.
-222 Data out of range;period; value clipped to ...
Example: If the period was set to a value out of
range, it is automatically set to an upper or lower
limit.