GW Instek GSP-830 User Manual User Manual
0ghz spectrum analyzer
Table of contents
Document Outline
- Safety Symbols
- Safety Guidelines
- GSP-830 Characteristics
- Package Contents
- Front Panel Overview
- Rear Panel Overview
- Display Overview
- Tilt Stand & Power Up
- Error Check
- Functionality Check
- Operation Shortcuts
- Menu Tree
- Preset Contents
- View Signal (Center and Span)
- View Signal (Start and Stop)
- Full/Zero Span
- Recall the Last Span Setting
- Set Vertical Scale
- Amplitude Correction
- Use Pre-Amplifier (Optional)
- Set Input Impedance
- How Autoset Works
- Run Autoset
- Limit vertical search range
- Limit horizontal view range
- Activate/de-activate marker
- Move marker
- Show Markers in Table
- Search Signal Peak
- Show Peak Table
- View traced waveform
- Move Marker to Trace
- Run Trace Math
- Select Signal Detection Mode
- ACPR Measurement
- OCBW Measurement
- N dB Measurement
- Phase Jitter Measurement
- Edit Limit Line
- Run Pass/Fail test
- Select RBW (Resolution BandWidth)
- Select VBW (Video BandWidth)
- RBW/VBW Auto Mode Contents
- Set Sweep time
- Average Waveform
- Select Trigger Type
- Select Trigger Mode
- Set Trigger Delay
- Change Display Brightness
- Activate Display Line
- Enter Display Title
- Use Split Display
- Use VGA Output
- Save Display Image to USB Flash Drive
- File Location and File Type
- Copy File
- Delete File
- Rename File
- Save Display Image to USB Flash Drive
- Save/Recall Panel Setting
- Configure Communication Interface
- View System Information
- Set Date/Time
- Synchronize GSP-830 with Other Devices
- Select Language
- Use Auxiliary Signal
- Enter Service Operation
- Edit Sequence
- Run Sequence
- 1. Select sequence
- 2. Select running mode
- 3. Run sequence
- Save/copy/delete/rename sequence file
- Activate tracking generator
- Normalize tracking generator
- Check TG installation status
- Activate demodulation
- Activate phone output
- Set phone output volume
- Cut off phone output noise (squelch)
- Check Demodulator installation status
- Select average/ quasi peak signal detection mode
- Select 9kHz/120kHz RBW
- Check EMI filter installation status
- Battery Operation
- DC Operation
- Install Software
- Connect Software
- Use Software
- Configure Interface
- Command Syntax
- Command Set
- GSP-830 Specifications
- Optional Items Specifications
- Declaration of Conformity