GW Instek GSP-830 User Manual - Manual (Page 166)

GSP-830 User Manual
166
meas:ocbw? Returns the OCBW activation/deactivation status.
Parameter:on,off
meas:ocbw Turns On/Off OCBW. Parameter: on, off
Example: meas:ocbw_on
meas:ocbw:bw? Returns the power measurement channel space in kHz.
meas:ocbw:per? Returns OCBW percentage.
meas:ocbw:per Sets OCBW percentage. Example: meas:ocbw:per_90 (90%)
meas:ndb? Returns N dB activation status. Parameter: on, off
meas:ndb Turns on/off N dB. Parameter: on, off Example: meas:ndb_on
meas:nbw:ndb? Returns N dB bandwidth. Example: 1000 khz
meas:nbw:ndb Sets N dB. Example: meas:ndb:ndb_3 (3 dB)
meas:jitter? Returns Phase Jitter on/off status. Parameter: on, off
meas:jitter Turns On/Off Phase Jitter. Parameter: on, off
Example: meas:jitter_on
meas:jitter:stoffs? Returns Phase Jitter start offset. Example: 0 khz
meas:jitter:stoffs Sets Phase Jitter start offset. Need to specify the unit.
Example: meas:jitter:stoffs_0_khz
meas:jitter:stpoffs? Returns Phase Jitter stop offset. Example: 50 khz
meas:jitter:stpoffs Sets Phase Jitter stop offset. Need to specify the unit.
Example: meas:jitter:stpoffs_50_khz
meas:jitter:phase? Returns Phase Jitter phase in radian. Example: 1.234 rad
meas:jitter:time? Returns Phase Jitter time in pico second. Example: 1.234psec
Limit line
meas:lmtline:on Turns On limit line. Parameter: 0 (low limit line), 1 (high limit
line) Example: meas:lmtline:on_0 (low limit line On)
meas:lmtline:off Turns Off limit line. Parameter: 0 (low limit line), 1 (high limit
line) Example: meas:lmtline:off_0 (low limit line Off)
meas:lmtline:passfail? Returns Pass/Fail test result. Parameter: on, off
meas:lmtline:passfail Turns On/Off Pass/Fail test. Parameter: on, off
Example: meas:lmtline:passfail_on (Pass/Fail test On)
meas:lmtline:
passfail:criterion? Returns Pass/Fail test criteria.
Parameter: 1 (pass if all signals are in the zone), 2 (pass if the
peaks are in the zone), 3 (pass if valleys are in the zone)
meas:lmtline:
passfail:criterion Sets Pass/Fail test criteria.
Parameter: 1 (pass if all signals are in the zone), 2 (pass if the
peaks are in the zone), 3 (pass if valleys are in the zone)
Example: meas:lmtline:passfail:criterion_3
meas:lmtline:table? Returns limit line table On/Off. Parameter: on, off
meas:lmtline:table Turns On/Off limit line table. Parameter: on, off
Example: meas:lmtline:table_on (limit line table On)