GW Instek GSP-830 User Manual - Manual (Page 161)

REMOTE CONTROL
161
Command Set
•
Commands are non-case sensitive.
•
Underline means a single space (100_mhz→100 mhz).
IEEE488.2 standard commands
*cls Clear Status Command
*ese? Standard Event Status Enable Command
*ese Standard Event Status Enable Query
*esr? Standard Event Status Register Query
*idn? Identification Query. Parameter: Manufacturer, Model, Serial
number, Firmware version. Example: GW, GSP-830, P920130,V3.01
*opc? Operation Complete Command
*opc Operation Complete Query
*rst Reset Command
*sre? Service Request Enable Command
*sre Service Request Enable Query
*stb? Read Status Byte Query
*tst? Self-Test Query
*wai Wait-to-Continue Command
Frequency
meas:freq:cen? Returns the center frequency in kHz. Example: 1000000 khz
meas:freq:cen Sets the center frequency. Example: meas:freq:cen_100_mhz
meas:freq:st? Returns the start frequency in kHz. Example: 1000000 khz
meas:freq:st Sets the start frequency. Example: meas:freq:st_100_mhz
meas:freq:stp? Returns the stop frequency in kHz. Example: 1000000 khz
meas:freq:stp Sets the stop frequency. Example: meas:freq:stp_100_mhz
meas:freq:ss? Returns the frequency step size in kHz. Example: 1000000 khz
meas:freq:ss Sets the frequency step. Example: meas:freq:ss_100_mhz
meas:freq:cen:fw Moves the center frequency one step size forward.
meas:freq:cen:bw Moves the center frequency one step size backward.
Span
meas:span? Returns the frequency span in kHz. Example: 10000 khz
meas:span Sets the frequency span. Example: meas:span:10_mhz
meas:span:full Sets the frequency span to full.
meas:span:zero Sets the frequency span to zero.
meas:span:last Recalls the last frequency span setting.