GW Instek GSP-830 User Manual - Manual (Page 67)

MARKER
67
Move marker to trace
Panel operation 1. Check the active marker at the
top right corner of the display.
2. Press the Marker key.
Marker
3. Press F6 (More).
More F 6
4. Press F1 (Marker Trace).
Marker Trace
Auto A B C
F 1
Range Auto The marker moves to the active signal/trace.
TraceA The marker moves to TraceA.
TraceB The marker moves to TraceB.
TraceC The marker moves to TraceC.
Show Markers in Table
Panel operation 1. Check the active marker at the
top right corner of the display.
2. Press the Marker key.
Marker
3. Press F6 (More).
More F 6
4. Press F2 (Marker Table On).
Marker Table
On Off
F 2
5. The marker ID, frequency, and amplitude list
appears in the lower half of the display, updated in
real time.
Display