GW Instek GSP-830 User Manual - Manual (Page 173)

Appendix
173
Display 640 x 480 high-res color TFT LCD
Split Windows
Active Window: Upper, Lower, or Alternate (two
simultaneously sweeping windows)
Markers
10 markers for peaks: 5 normal-delta marker
pairs. Function: Delta, To Peak, To Minimum,
Peak Track, Peak Table, Peak Sort
Trace Detection
3 traces with Peak, Maximum hold, Freeze,
Average, and Trace Math
Power Measurement
ACPR, OCBW, Channel power, N dB, and Phase
Jitter
Autoset Function
Auto tuning the measurement result for
observation
Trigger
Conditions: Video, External (Positive-going
+5V-TTL ext. signal) Modes: Normal, Single,
Continuous
General
Sequence
Automated test by user defined macros without
any remote controller.
10 sequential macro sets and 10 macros per
each set. Variable Delays and Wait-to-Go
facilitate automated measurement.
Do-Sequence links and nests different sequence
sets.
RF Input
Type: N Female, 50Ω nominal
RF input VSWR: <2:1, @0dBm Ref Lvl
External Reference
Clock Input (MHz) Type: BNC Female, 1M, 1.544M, 2.048M, 5M,
10M, 10.24M, 13M, 15.36M, 15.4M, 19.2M
Ref. Clock Output Type: BNC Female, 10MHz
DC Input (DC Power
Operation)
Jack: 5.5mm, 12V
Connectors
DC Output (for
pre-amplifier)
Type: SMA Male, output +9V/100mA max.
RS-232C Sub-D 9pins Female
USB Connector
USB Host/Device fully supported
Front Panel: Type A receptacle for USB flash
drives. Rear Panel: Type mini-B receptacle for
PC remote control.
VGA Output Sub-D 15pins Female
Interface
GPIB (option) Fully programmable with IEEE488.2 compliance
Accessories
User Manual x1, Power Cord x1, USB Cable (Type A plug to Type mini-B
plug) x 1
Power Source AC 100V to 240V, 50/60Hz
Dimensions &
Weight
330 (W) × 170(H) × 340(D) mm, Approx. 6kg
Operation
Environment Temperature: 18℃ to 28℃
Relative Humidity: < 90%
Storage Environment
Temperature: 0℃ to 40℃
Relative Humidity: < 85%