beautypg.com

Location: indoor, Relative humidity: < 85, Temperature: 0°c to 40°c – GW Instek GSP-830 User Manual User Manual

Page 7

background image

SAFETY

INSTRUCTIONS

7

Use only mating connectors, not bare wires, for the

terminals.

Do not block or obstruct the cooling fan vent opening.

Do not perform measurement at a power generating source
or building installation site (Note below).

Do not disassemble the GSP-830 unless you are technically
qualified.

(Note) EN 61010-1:2001 specifies the measurement categories and
their requirements as follows. The GSP-830 falls under category II.

Measurement category IV is for measurement performed at the
source of low-voltage installation.

Measurement category III is for measurement performed in the
building installation.

Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.

Power Supply

WARNING

AC Input voltage: 100 to 240 V AC, 50/60Hz, 90W
maximum

DC Input voltage: 12V DC, 40W maximum

The power supply voltage should not fluctuate more than

10%.

Connect the protective grounding conductor of the AC

power cord to an earth ground, to avoid electrical shock.

Battery

CAUTION

Rating: 11.1V lithium-ion battery pack x 2

Turn off the main power switch before installing or taking

out the battery packs.

Fuse

WARNING

Fuse type: T1.6A/ 250V, time-delay, 5x20mm glass

To ensure fire protection, replace the fuse only with the

specified type and rating.

Disconnect the power cord before fuse replacement.

Make sure the cause of fuse blowout is fixed before fuse
replacement.

Cleaning the
GSP-830

Disconnect the power cord before cleaning.

Use a soft cloth dampened in a solution of mild detergent

and water. Do not spray any liquid into the GSP-830.

Do not use chemicals or cleaners containing harsh
products such as benzene, toluene, xylene, and acetone.

Operation
Environment

Location: indoor, no direct sunlight, dust free, almost
non-conductive pollution (Note below)

Relative Humidity: < 90%

Altitude: < 2000m

Temperature: 18°C to 28°C

Storage
Environment

Location: indoor

Relative humidity: < 85%

Temperature: 0°C to 40°C