GW Instek GSP-830 User Manual - Manual (Page 19)

GETTING STARTED
19
H Status Icon The icons showing various system conditions. See the
below Status Icon overview for details.
I Test Result/
Error Message
The result of the pass/fail test using limit lines (page94)
or the system error messages (page128).
J Command
Window
Shows the current status of the selected menu or the
entered parameters such as frequency and amplitude.
Status Icon overview
Amplitude
(page48) External gain on, amplitude correction on, Input
impedance 75Ω, Input impedance calibration on
Peak Search
(page68) Peak track on
TraceA:green , B:red , C:yellow
Clear mode Average on
Trace (page73)
Peak hold mode View mode, trace math
BW (page95) RBW, VBW manual
mode Sweep time manual mode
Trigger (page103) Video trigger mode External trigger signal on
Fully charged 50% to 25% Battery level
(page148)
75% to 50% Less than 25%
Options TG normalization
activated (page142) External reference signal
used (page133)
±1ppm stability module installed (page133)
Sequence(page136) Sequence currently running
USB USB flash drive is detected (page114), or USB
remote control connection is detected (page158)