GW Instek GSP-830 User Manual - Manual (Page 158)

GSP-830 User Manual
158
Configure Interface
Interface type USB slave USB 1.1 or 2.0, type B mini
RS-232C D-sub 9 pin
GPIB (optional) 24 pin
No need for panel configuration:
Just connect a type B mini USB
cable to the rear panel. USB slave port
configuration
The USB icon turns on when
the connection is detected.
RS-232C
configuration 1. The RS-232C configuration can
be checked from the system
menu. Press the System key.
System
2. Press F3 (Serial Port).
Serial Port.. F 3
3. The RS-232C port
configuration appears.
Configure the PC according to
this setting.
Baud: 57600
Parity: None
Stop bit: 1
Data bit: 8
Stop
1
F 3
Baud
57600
F 1
Parity
None
F 2
Data
8
F 4
4. Connect a 9-pin male RS-232C
cable to the rear panel terminal.
GPIB (optional)
configuration GPIB interface is a factory installed optional item.
Contact the service center for a new installation.
1. Press the System key.
System
2. Press F2 (GPIB Add).
GPIB Add
8
F 2