GW Instek GSP-830 User Manual - Manual (Page 170)

GSP-830 User Manual
170
Option
con:opt:tg Turns On/Off Tracking Generator (TG). Parameter: on, off
Example: con:opt:tg_on (TG On)
con:opt:tg:level? Returns the TG level.
con:opt:tg:level Sets the TG level.
con:opt:tg:norm Turns On/Off TG normalization. Parameter: on, off
Example: con:opt:tg:norm_on (normalization On)
con:opt:tg:offset Sets the TG offset level.
con:opt:tg:refval? Returns the TG reference value.
con:opt:tg:refval Sets the TG reference value.
con:opt:dm:fm Turns On/Off FM in the demodulator. Parameter: on, off
Example: con:opt:dm:fm_on (FM On)
con:opt:dm:am Turns On/Off AM in the demodulator. Parameter: on, off
Example: con:opt:dm:am_on (AM On)
con:opt:dm:spk Turns On/Off phone output in the demodulator.
Parameter: on, off Example: con:opt:dm:spk_on (phone On)
con:opt:dm:vol Sets the demodulator phone output volume.
con:opt:dm:sql? Returns the demodulator squelch level.
con:opt:dm:sql Sets the demodulator squelch level.
con:opt:bat? Returns the battery level.
con:opt:extreffreq? Returns the external reference frequency.
con:opt:extreffreq Sets the external reference frequency.
Sequence
con:seq:runmode Selects the sequence run mode.
Parameter: 1 (repeat mode), 2 (single mode)
Example: con:seq:runmode_2 (sequence runs in sing mode)
con:seq:runseq Runs the sequence. Parameter: sequence index, 1 to 10
Example: con:seq:runseq_2 (run sequence 2)
con:seq:stopseq Stops the running sequence.
con:seq:delallseq Deletes all programmed sequence.
con:seq:delseq Deletes a sequence. Parameter: sequence index, 1 to 10
Example: con:seq:delseq_2 (delete sequence 2)