GW Instek GSP-830 User Manual - Manual (Page 29)

QUICK REFERENCE
29
Set Trigger Frequency Trigger→F5
Run Trigger (in Single/Continuous) Trigger→F6
Display
Change Dimmer Level Display→F1
Show Display Line Display→F2
Clear Title Display→F3→F1
Enter Title Display→F3→F2 to F4
Show Title Display→F3→F5
Activate Split Window Display→F4→F1 (Upper), F2 (Lower)
Alternate Upper/Lower Sweep Display→F4→F3
Switch Split Display to Full Screen Display→F4→F4
File
Select Copy Source File File→F1→F1→F1 to F5
Select Copy Destination File F2→F1 to F5 (After Selecting Source)
Edit Copied File Name F3 (After Selecting Destination)
Copy Selected File F4 (After Selecting Source/Destination)
Select File for Deletion File→F2→F1→F1 to F5
Delete Selected File F2 (After Selecting File)
Rename File File→F3→F1
Confirm New File Name F2 (After Renaming File)
Save Display Image to USB Drive File→F4→F1→F2
Rename File in USB Drive File→F4→F1→F1
Select System Code for Update File→F5→F1→F1
Select Language for Update File→F5→F1→F2
Update System File from USB Drive F2 (After Selecting File)
Preset
Recall Factory Installed Settings Preset
System
Save Setup System→F1→F1 or F2→F3
Recall Setup System→F1→F1 or F2→F4
Select GPIB Address System→F2
Show RS-232C Configuration System→F3→F1 to F4
Activate Auxiliary Signal System→F4