GW Instek GSP-830 User Manual - Manual (Page 157)

REMOTE CONTROL
157
R
EMOTE CONTROL
The GSP-830 supports remote control which is partially
based on IEEE 488.2 and SCPI (Standard Commands
for Programmable Instrumentation) standards. The
command set covers most of the panel operations. Three
interfaces are available: USB slave, RS-232, and GPIB.
Interface Configure Interface .............................................. 158
Command Syntax Command Syntax ................................................. 160
Command Set IEEE488.2 standard commands ........................... 161
Frequency ............................................................ 161
Span .................................................................... 161
Amplitude ............................................................ 162
Autoset ................................................................ 162
Marker & Peak Search ......................................... 163
Trace .................................................................... 164
Power measurement ............................................ 165
Limit line ............................................................. 166
BW ....................................................................... 167
Trigger ................................................................. 167
Display................................................................. 168
File ...................................................................... 168
Preset .................................................................. 169
System ................................................................. 169
Option ................................................................. 170
Sequence ............................................................. 170