IAI America RCS3PCR-SS8C - Manual (Page 71)

6. Connection with Controllers
61
When fixing the cable, provide a moderate slack and do not tension it too tight.
Separate the I/O lines and communication lines from the power/drive lines. Do not bundle them together in
the duct.
Warning:
necting any cable, be sure to turn off the controller power first. If
a cable is connected or disconnected while the power is still supplied, the actuator may
malfunction and a serious injury or equipment damage may result.
firmly in place, because any loose connector may
cause the actuator to malfunction and create a dangerous situation.
Do not use a spiral tube where
the cable flexes frequently.
Power line
Signal lines (flat cable)
Duct
Follow the instructions below when using a cable track.
• If there is an indication to the cable for the space factor in a cable track, refer to the wiring instruction given
by the supplier when storing the cable in the cable track.
• Avoid the cables to get twined or twisted in the cable track, and also to have the cables move freely and do
not tie them up. (Avoid tension being applied when the cables are bent.)
Do not pile up cables. It may cause faster abrasion of the sheaths or cable breakage.