IAI America RCS3PCR-SS8C - Manual (Page 55)

5. Installation
45
5.2 Notes on Installation
The stainless sheet is designed very thin (thickness: approx. 0.1 mm) in order to ensure flexibility. Therefore, the
stainless sheet is easily dented or scratched. Once dented or scratched, the stainless sheet may break during
use.
When installing the stainless sheet, pay attention to the following points:
1. Do not press the sheet directly with hands 2. Protect the sheet from dents by paying attention not to
drop tools and work parts onto the sheet.
3. Do not allow powder dust or iron powder to generate around the stainless sheet.
If generation of powder dust/iron powder cannot be fully prevented, wipe the stainless sheet after the
operation to remove all particles attached to the sheet.
If the actuator is operated with the stainless sheet carrying foreign particles, the particles may enter the
slider and damage the sheet or cause the sheet to deform, lift or present other problems.
The stainless sheet is held in place by means of magnets. If surrounding air contains iron powder or other
magnetic substances, they may attach to the magnets and cause problems. Pay attention to the
surrounding environment and take appropriate measures, if necessary.
Dent