IAI America RCS3PCR-SS8C - Manual (Page 218)

0
11. Maintenance and Inspection
198
198
25) Use an Allen wench of 2 mm across flats to tighten the two screws to install the stainless sheet.
26) Install the clearance check jig to adjust the stainless sheet.
27) Adjust the tension of the stainless sheet.
[1] While looking through the center opening in the clearance-checking tool, move the stainless sheet on the
loose end in the directions of arrows until the clearance between the top face of the stainless sheet and the
back of the clearance-checking tool falls within the specified range.
[2] When the stainless sheet has been properly positioned, tighten the screws on the loose end to a level that
the stainless sheet no longer moves.
Move the stainless sheet in the directions of arrows to adjust the tension.
While looking through the center opening, check the clearance between the top face of
the stainless sheet and the back of the clearance-checking tool. (If the clearance is within
the specified tolerance range, the tension is appropriate even when the clearance varies
along the entire stroke or between right and left.)
Tightening Torque
Stainless sheet bolts
Install the clearance
check jig in place for
the slider cover.
Outer openings
Center opening