Luminex 100 IS User Manual, Version 2.1 - Manual (Page 27)

PN 89-00002-00-061 Rev. A 4 - 1
Installation
Assemble and
Power the Luminex
100 IS System
Before installing the system, ensure that the facility complies with all
system and safety requirements. Read the safety information that
begins in
“Safety Precautions” on page 2-2 . Try to position the
instrument to minimize temperature fluctuations.
Hardware Setup
The following sections describe how to set up the hardware
components of the Luminex 100 IS.
Connect the
Luminex 100
Analyzer and XYP
Instrument
‹ To assemble and power on the system:
1. Unpack the Luminex 100 analyzer, the XYP instrument, and the
PC and monitor. Review “Hardware” on page 5-2 and identify
each system component.
2. Place the XYP instrument on a clean, flat surface.
Figure 1. Red Shipping Pin
3. Remove the red shipping pin. Leave the silver knob in the XYP
instrument.
4. Attach the power cord to the power input module of the XYP
instrument and attach the communication cable to the XYP
4
Red shipping pin
Note: Due to the weight of the
Luminex 100 analyzer, two people
are required for lifting.