Luminex 100 IS User Manual, Version 2.1 - Manual (Page 121)

x MAP Technology Software Tour
PN 89-00002-00-061 Rev. A 7 - 61
Calibration Trend Report. This report provides information
about all calibration operations that occurred during the date range
entered by the operator.
System Control Trend Report. This report provides information
about all verification operations that were performed during the date
range entered by the operator.
You must enter information about the batch for which you want to
print a report.
‹ To create a report from a batch or a specific time frame:
Ensure that you install the printer before initiating the print
command.
1. Click the Print button on the toolbar. A Report Selection dialog
box appears.
Figure 75. Report Selection Dialog Box
2. Select the type of report you want to print and click Next. A
dialog appears prompting you for information. The information
that the system requests may vary depending on the type of
report that you select.