Luminex 100 IS User Manual, Version 2.1 - Manual (Page 102)

100 IS S Users Manual Version 2.1 x MAP Technology
7 - 42 PN 89-00002-00-061 Rev. A
If any of the acquire sample commands within the template of
the batch has any unassigned value, the system applies the first
patient ID in the list to the unassigned sample acquisition
command. The system appends any remaining patient IDs to the
end of the command list in order as they appear in the patient
list.
If all patient IDs in the batch or multi-batch are identified, the
system appends the patient list items to the first empty location
after the batch’s or multi-batch’s last command list activity.
An assigned value is the patient label by which you recognize the
sample and might take the form of a barcode entry number you
scanned into the system or the sample ID entered manually.
See “Add a Patient List to a Batch or Multi-Batch” on page 7-49
for information regarding the patient file format.
10. Click either Save and Load (default) or Save Only.
11. Click Finish. If you selected Save and Load, the Run Batch tab
appears showing you the batch, including the samples you added.
If you selected Save only, the system becomes idle as it waits for
you to initiate a command.
Open a Batch You may have created a batch and not loaded it for processing at a
later date. You may then open the batch for processing at your
convenience.
‹ To open a batch:
1. Click Open Batch from the toolbar on the main screen. An Open
Batch dialog box appears listing available batches appears.
2. Select the batch that you want to open.
3. Click Open. The system loads the procedure associated with the
batch as you created it.