Clear-Com Eclipse-Omega - Manual (Page 80)

Eclipse Upgrade Reference Manual
Clear-Com Communication Systems Page 80 of 155 Part Number: 810377Z Rev 6
8.2 FPGA Xilinx Upgrade
Upgrade of FPGA Xilinx images on Eclipse EQue cards requires the use of specialist
equipment and cannot normally be carried out in the field.
To program the flash prom, a PC or laptop with the Xilinx iMPACT programming
software and a Xilinx Download Cable i.e. Platform cable USB model DLC9G will be
required.
The XilInk programming tool,XilInx iMPACT, may be obtained by downloading ISE
WebPACK™ from the following website.
http://www.xilinx.com/xlnx/xil_sw_updates_home.jsp
Unfortunately, you will have to make an account on the site before you can download
and a licence agreement will need to be accepted before download.
8.3 Programming
1. Obtain the latest versions of the Xilinx device firmware required from:
InstallCD\Omega-Median\710807Z - E-Que FPGA\710807Z-PROG-2.mcs
2. Connect the USB connector of the download cable (Platform cable USB
DLC9G) to the computers USB port. Connect the 14way IDC header to
CON3100.
3. Power up the UUT and start the iMPACT programming tool.
4. Select Cancel in the Load Project dialogue.
5. In the ‘Modes’ window, double click on ‘Boundary Scan’.