Clear-Com Eclipse-Omega - Manual (Page 40)

Eclipse Upgrade Reference Manual
Clear-Com Communication Systems Page 40 of 155 Part Number: 810377Z Rev 6
6. Set the board DIP switches into Test mode as shown below:
Figure 24 - E-Pico/E-32 Switches in Test mode
7. Power cycle or reset the E32/Pico so that the DIP switch changes come into
effect.
8. Confirm that the Configuration card has entered test mode. You should see the
following display:
Figure 25 - E-32 Boot Output
• Note that sometimes you may need to hit the return key a few times
to get this screen to come up.
• You can press "?" to see all available options in the test mode.
• You can press "i" to see that all current application that is loaded on
the CPU.
9. On the keyboard press number 1 then press [enter] or [return] to start the
erase of Flash. Confirm that you want to erase Flash by selecting ‘y’ and press
[enter]. (Erasing Flash will take approximately 1 minute to complete) and is
followed by a considerable number of “Sector Erase” messages.
10. Once the flash erase is complete, press number 2 then press [enter] or [return]
to start the erase of NVRAM. This will generate”RAM Test” messages.
11. Place the board DIP switches into normal mode for a new application
download as shown below.