Clear-Com Eclipse-Omega - Manual (Page 26)

Eclipse Upgrade Reference Manual
Clear-Com Communication Systems Page 26 of 155 Part Number: 810377Z Rev 6
Figure 14 - Serial Port Configuration
6. Configure the serial port as follows the click on ‘OK’:
COM1: (change as required to match a COM port present on
the PC)
Baud Rate: 115200
Parity:
Even
Data Bits: 8
Stop Bits: One
7. Connect the serial communications lead between the PC serial port or USB
port and the RS232 port on the rear of the matrix frame.
8. Remove both the configuration cards from the frame.
9. Place configuration card into TEST mode.
10. Set the DIP switches on the configuration card as shown below.