Clear-Com Eclipse-Omega - Manual (Page 18)

Eclipse Upgrade Reference Manual
Clear-Com Communication Systems Page 18 of 155 Part Number: 810377Z Rev 6
3.5 Eclipse Configuration Card Application using ECS (Ethernet)
This upgrade procedure is for an Ethernet connection for which there must be a valid
configuration map in the frame. This is necessary so that the rack can start running
properly and so know it's IP address and be running its TCP/IP stack.
Before using this procedure - check that the matrix event log can connect serially to
a card with a configuration.
3.5.1 Required Equipment
1. PC with serial Ethernet port connection or USB port and USB to serial cable.
2. Configured and working ECS installation.
3. ECS configuration file (.ccn format) with appropriate IP addresses set.
4. Appropriate .4kr file for Eclipse Configuration Card application.
InstallCD\Omega-Median\710621Z - Config App\710621Z.4kr
5. LAN cable for PC to Eclipse interconnection.
• Use Ethernet crossover cable if your connection is going direct from PC to
Matrix.
• Use Straight CAT5 cable if your connection is going via a Ethernet Hub /
Switch to PC and matrix.
3.5.2 Upgrade Steps
3.5.2.1 Opening the Linked set or Layout information
1. Start ECS and log in.
2. Click on Open map and select basic configuration with the appropriate IP
addresses set.
3. Select File -> Matrix connection.
4. Select the Ethernet communications option in the matrix connection dialogue
then click on OK.
5. Connect the LAN lead between the PC Ethernet port and theLAN#1 port on
the rear of the matrix frame.
6. Both configuration cards may remain in situ during this upgrade.
7. Select File -> Update Firmware from the ECS main menu.
8. Click on Next within the firmware update wizard dialogue displayed.
9. Ensure that ‘Frame’ is selected in the next firmware update dialogue then click
‘Next’.
10. Click on ‘Browse’ and navigate to the required .4kr file for Eclipse
Configuration Card application.
11. Click on ‘Open’ within the ‘Browse’ dialogue and ensure that the correct file
name is displayed in the firmware update wizard dialogue.
InstallCD\Omega-Median\710621Z - Config App\710621Z.4kr