Tel-14, Introduction, 2 upgrading the hardware – Clear-Com Eclipse-Omega User Manual
Page 115: 1 requirements, 2 procedure, Upgrading the hardware, Eclipse upgrade reference manual
Eclipse Upgrade Reference Manual
Clear-Com Communication Systems
Page 115 of 155
Part Number: 810377Z Rev 6
12 TEL-14
12.1 Introduction
This section describes the replacement Tel-14 processor;
How to re-fit Tel-14 cards;
Update the firmware.
12.2 Upgrading the Hardware
12.2.1 Requirements
1. Old Tel-14 Card
2. Replacement Processor Module
3. FlashMagic Software:
InstallCD\3rd_Party_Software\FlashMagic\FlashMagic.exe
4. TEL-14 Application Software
InstallCD\Other_Software\710756|-TEL-14 Application\710756Z-PROG-
2.HEX
12.2.2 Procedure
1. Remove the four screws securing the front panel and remove it.
2. Remove the three screws securing the PCB that does not have the backplane
connector and open the two cards up. It is not necessary to disconnect the two
cards.
3. Remove the original Processor, IC20 from its socket. (Figure 19)
4. Replace with new processor module, ensuring that it is in the right way round,
the blue serial connector should be farthest away from the front panel (Figure
20)