Clear-Com Eclipse-Omega - Manual (Page 27)

Eclipse Upgrade Reference Manual
Clear-Com Communication Systems Page 27 of 155 Part Number: 810377Z Rev 6
Figure 15 - CPU DIP Switches in Test Mode
11. Insert the configuration card into the matrix frame.
12. Confirm that the Configuration card has entered test mode. You should see the
following display:
Figure 16 - Boot Display
13. Note: if you do not see this screen press the enter button on the PC.
14. On the keyboard press number 1 then press [enter] or [return] to start the
erase of Flash. Confirm that you want to erase Flash by selecting ‘y’ and press
[enter]. (Erasing Flash will take approximately 1 minute to complete).
15. Once the flash has been erased, press number 2 then press [enter] or [return]
to start the erase of NVRAM.
16. Once the NVRAM erase is complete, remove the Configuration Card.
• Note – you can press “?” to see all available options in the test mode.
• Note – you can press “i“ to see that all current application that is loaded on
the CPU
17. Place configuration card into normal mode for new application download.
18. Set the DIP switches to normal mode as shown below.