B&B Electronics VFG3000 - Manual User Manual
Page 376
F
IELDBUS
G
ATEWAY
M
ANAGER
M
ESSAGES
V
LINX
F
IELDBUS
G
ATEWAY
M
ANAGER
U
SER
M
ANUAL
P
AGE
360
F
IELDBUS
G
ATEWAY
M
ANAGER
M
ESSAGES
E
RRORS
P
OSSIBLE
C
AUSES
P
OSSIBLE
S
OLUTIONS
Device incompatible
with file.
The device you are trying to download
into doesn’t match the database device.
Create a new database file
corresponding to your device
(File > New).
Unable to open
communication port.
The communication port you try to
download with is unavailable.
Cable not connected
Check if the cable is connected
correctly to the PC and the device
programming ports (USB or PG Port).
Incorrect download
communication port
Check that Fieldbus Gateway Manager
is directed to the correct
communication port (Link > Options).
Port already used
Check that the communication port is
not used by another service or software
especially for serial ports.
Target device IP
address incorrect
If you download via Ethernet, Check
the IP address of the target device in
Link > Options.
No USB Drivers
Check that the USB drivers were
install successfully. Reinstall USB
driver under the PC device manager if
necessary.
No Reply from
terminal
Cable is not connected
Make sure the cable is connected or
check above solutions
If the message appears while
downloading to the device
Download again with Link > Update
or F9
CompactFlash
required for upgrade.
The version of Fieldbus Gateway
Manager on the PC is different from
the target device firmware version
when attempting a download via
Ethernet.
Insert a CompactFlash Card in the
target device.
Use another communication port for
download; USB or Serial.
The window is too
small to allow
editing.
The current User interface view is too
small to allow editing.
Change the view using View > Panel >
Display only.
The device returned
an unexpected reply
code.
The device you are trying to download
to is not supported by this version of
Fieldbus Gateway Manager.
Update Fieldbus Gateway Manager to
the latest version available.
Choose Repair when upgrading.