ZyXEL Communications IES-612-51A - Manual (Page 372)

Chapter 52 ADSL Commands
IES-612-51A User’s Guide
372
This command configures settings and thresholds that define when the IES-612-51A is to send
an alarm trap and generate a syslog entry.
Configure alarm profiles first and then use the alarmprofile map command to set the IES-
612-51A to use them with specific DSL ports.
The following example sets an alarm profile named SESalarm that has the IES-612-51A send
an alarm trap and generate a syslog whenever the upstream connection’s number of severely
errored seconds exceeds three within a 15 minute period.
52.3.3 Alarm Profile Delete Command
Syntax:
ras> adsl alarmprofile delete
where
This command allows you to delete an individual alarm profile by its name. You cannot delete
the DEFVAL alarm profile.
The following example deletes the SESalarm alarm profile.
52.3.4 Alarm Profile Map Command
Syntax:
ras> adsl alarmprofile map
where
fast>
= The number of failed fast retrains that are permitted to occur
within 15 minutes.
= The number of Severely Errored Seconds that are permitted
to occur within 15 minutes.
= The number of UnAvailable Seconds that are permitted to
occur within 15 minutes.
Figure 254 Alarm Profile Set Command Example
ras> adsl alarmprofile set SESalarm 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2 0 3
0 0 0
= The name of an alarm profile.
Figure 255 Alarm Profile Delete Command Example
ras> adsl alarm profile delete SESalarm
= You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
= The name of an alarm profile.