4 route delete command, 5 route show command, Figure 196 route show command example – ZyXEL Communications IES-612-51A User Manual
Page 333
Chapter 49 IP Commands
IES-612-51A User’s Guide
333
where
This command defines a new, static IP forwarding route or edits an existing one.
49.3.4 Route Delete Command
Syntax:
ras> ip route delete
where
This command removes a static, IP forwarding route.
49.3.5 Route Show Command
Syntax:
ras> ip route show
This command displays the IES-612-51A’s routing table.
An example is shown next.
=
The destination IP address of packets that this static route is
to route.
[/netmask]
=
The destination subnet mask of packets that this static route
is to route.
=
The IP address of the gateway that you want to send the
packets through.
[metric]
=
The metric (hop count) of this static route.
=
A name to identify this static route. Up to 31 ASCII
characters. Spaces and tabs are not allowed.
default
=
Use this to configure the IES-612-51A’s default route.
=
The destination IP address of packets to which this static
route applies.
[/netmask]
=
The destination subnet mask of packets to which this static
route applies.
Figure 196 Route Show Command Example
ras> ip route show
index dest gateway metric name
----- --------------- --------------- ------ ------------------------------
-
1 192.168.1.0/24 192.168.1.1 1
2 default 192.168.1.254 1