ZyXEL Communications IES-612-51A - Manual (Page 345)

Chapter 52 ADSL Commands
IES-612-51A User’s Guide
345
The following example displays the DSL DEFVAL profile.
52.1.5 DSL Port Profile Set Command
Syntax:
ras> adsl profile set ,]>
[
]
where
Figure 215 DSL Profile Show Command Example
ras> adsl profile show DEFVAL
01. DEFVAL latency mode: interleave
up stream down stream
--------- -----------
max rate (kbps): 512 2048
min rate (kbps): 32 32
latency delay (ms): 4 4
max margin (db): 31 31
min margin (db): 0 0
target margin (db): 6 6
up shift margin(db): 9 9
down shift margin(db): 3 3
= The descriptive name for the profile.
e[=
delay>,
delay>]>
= The latency mode. With interleave, you must also define the
upstream and downstream delay (1-255 ms). It is
recommended that you configure the same delay for both
upstream and downstream.
= The maximum DSL upstream transmission rate (64-4096
Kbps).
= The maximum DSL downstream transmission rate (64-
32000 Kbps).
margin>
= The target DSL upstream signal/noise margin (0-31db).
= The minimum acceptable DSL upstream signal/noise
margin (0-31db).
= The maximum acceptable DSL upstream signal/noise
margin (0-31db).
= The minimum DSL upstream transmission rate (32-4096
Kbps).
margin>
= The target DSL downstream signal/noise margin (0-31db).
margin>
= The minimum acceptable DSL downstream signal/noise
margin (0-31db).