ZyXEL Communications IES-612-51A - Manual (Page 331)

IES-612-51A User’s Guide
331
C
H A P T E R
4 9
IP Commands
This chapter shows you how to use the (standard shell) IP commands to configure the IP
(Internet Protocol) parameters.
49.1 IP Commands Introduction
Use the IES-612-51A’s management IP addresses to manage it through the network.
49.2 IP Settings and Default Gateway
Use the following command sequence to set the IES-612-51A’s IP settings for the Ethernet 1
and 2, and DSL ports, VID and default gateway. With the Ethernet 1 and 2, and DSL ports,
you must connect to the IES-612-51A through a port that is a member of the management
(CPU) VLAN in order to perform in-band management.
where
The first command changes the IP settings for the IES-612-51A’s uplink, downlink and IES-
612-51A DSL ports. If you don’t enter the subnet mask, the system automatically computes
the subnet mask.
Figure 194 IP Settings and Default Gateway Address Commands
ras> ip set []
ras> ip gateway
ras> config save
address>
= The IP address you want to configure for the IES-612-51A.
= The bit number of the subnet mask of the IP address you
want to configure for IES-612-51A’s uplink, downlink and
IES-612-51A DSL ports. To find the bit number, convert the
subnet mask to binary and add all of the 1’s together. Take
“255.255.255.0” for example. 255 converts to eight 1’s in
binary. There are three 255’s, so add three eights together
and you get the bit number (24).
= The default gateway IP address you want to configure for
the IES-612-51A.